If you state the properties of the pinion and the rotational ratio, your gear wheel may be designed fully with no further information, assuming it has the same thickness as the pinion. The gear is the driven (output) wheel and has the same tooth height and pitch as the pinion. See Hobbed Teeth vs Shaved or Ground Teeth below Gear If your pinion has non-standard tooth heights, you will also need to state the factor(s) to be applied to the addendum and/or dedendum. The following additional information is normally also requiredį) shaft diameter (including key dimensions) Its specification generally requires the following minimum information ( Fig 1): The pinion is usually (but not necessarily) the basis for sizing the driven gear. The pinion is the driver (or input) gear wheel fitted to the electric or diesel motor output shaft and provides the rotary movement that will be transferred to the driven gear (wheel).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |